AllSolar Energy

Leaks at the array

Solar Roof Leak Repair

A stain on the ceiling under the array is a solar problem until proven otherwise. We find the leak at the mount, flashing or conduit and seal it properly, on any brand of system.

Request Solar Repair

Where solar leaks start

A rooftop solar system is attached through the roof. Every attachment and every wire that passes into the attic is a hole that has to stay sealed for the life of the system. When one of them fails, water follows the rafter or the deck until it finds a place to drip, which may be several feet from the actual source.

Mounts and lag bolts

Rails sit on mounts that are bolted into the rafters. On a shingle roof each mount should sit on flashing slipped under the shingle above it. Some installers skipped the flashing and relied on sealant alone, which dries, cracks and lets water in years later. A bolt that missed the rafter, or was overtightened, can also crack the deck around it.

Tile roofs

Tile systems use hooks that pass under the tile to a mount on the underlayment. Tiles that were cut poorly, cracked during installation, or broken by someone walking on them later let water reach the underlayment at the worst spot. Often the fix is replacing the cracked tile and resealing the mount beneath it.

Metal roofs

Standing seam roofs usually take clamps on the seams with no penetration at all. Exposed fastener metal roofs are different. Each mount screws through the panel and needs the right gasket, and those gaskets age.

Conduit and junction box penetrations

Wiring from the array has to get to the inverter. Where it enters the attic through a roof penetration or a junction box, the seal is a common failure point, especially when the conduit has pulled or sagged.

What to do when you see a leak

Roofer or solar company?

If the leak is under or right beside the array, call the solar company first. A roofer usually cannot reach a mount under a panel without removing the panel, and many will not touch solar equipment at all. Removing panels involves electrical disconnects that should be handled by a licensed solar or electrical contractor.

If your roof is still under a roofer’s warranty, tell us, and contact the roofer as well. Some roofing warranties have conditions about who may work on the roof, and we would rather coordinate with your roofer than create a dispute. When the leak turns out to have nothing to do with the solar, such as worn underlayment, a failed pipe boot or flashing at a wall, we tell you plainly and you can bring in your roofer.

How we repair a leak at the array

We start in the attic when there is access, to trace staining and wet wood back toward the source. On the roof, we inspect the mounts, flashing, conduit entries and tiles in the area, and remove panels where the suspect mount is hidden underneath. A proper repair replaces failed sealant with real flashing where the roof type calls for it, resets a mount that missed its rafter, replaces cracked tiles, and reseals conduit entries with the right boots and fittings.

Then the panels go back, the system is tested, and you get photos of what we found and what we did. If wood damage under the deck is beyond a solar repair, we document it so your roofer has what they need.

An AllSolar Energy technician inspects rooftop solar mounts while a homeowner talks with the crew in the yard.

When the roof itself needs replacing

Sometimes a leak under the array is the first sign of a roof at the end of its life. Patching a worn roof under solar only buys time. In that case the right answer is to remove the panels, let the roofer replace the roof, and reinstall the system with new flashing on the new roof. We handle the takedown, storage and reinstall. See solar panel removal and reinstall for a new roof for how the reroof process works.

Solar pool heating panels leak differently, through the collectors and headers rather than the roof. For that, see solar pool panel leak repair. For everything else we fix, see solar repair and maintenance.

Frequently asked questions

Can solar panels cause roof leaks?

The panels themselves do not leak. The attachments and wiring penetrations that hold and connect them can, when flashing was skipped, sealant has aged, or a mount missed the rafter.

Should I call a roofer or a solar company for a leak under my panels?

Call the solar company first when the leak is under or beside the array, because reaching the source usually means removing panels. If your roof has a roofer’s warranty, let the roofer know as well so the repair is coordinated.

Do you fix leaks on systems another company installed?

Yes, on any brand of system and any installer, including companies that have closed.

Is roof sealant around the mounts good enough?

Sealant alone is not a lasting fix on most roof types. Shingle roofs need flashing under the shingle above each mount, and tile roofs need the tile and underlayment detail done correctly.

Do panels have to come off to fix the leak?

Often, for the panels directly over the suspected mount. We remove only what is needed to reach the source, then reinstall and test the system.

Will my homeowners insurance cover a leak under solar panels?

Coverage depends on your policy and the cause. We document what we find with photos and a written description you can share with your insurance company.

Florida Solar Contractor #CVC056660 · Electrical Contractor #EC13005027 · BBB A+ · Serving Florida since 1999 · 4.9 Google rating

Call 866-412-4218. We answer the phone.

Keep your solar records in one place

A free Solar Home account keeps your panels, inverter, batteries, pool heater or water heater on record: models, serial numbers, photographs of the labels, warranties, utility and interconnection documents, and every AllSolar service visit attached to your property.

Free to read first, no account needed: the Solar Home guides explain how to identify your equipment, what your production figures mean and what the common warnings are telling you.

Save My Equipment to Solar Home