A well installed solar pool heater in Florida usually needs a professional check about once a year, ideally in late winter or early spring before swim season. Between visits there is very little to do: keep the pool filter clean, watch for leaks or wet spots on the roof, and notice if the water is not warming the way it used to.
Solar pool heating has no compressor, no burner and no fuel. The pool pump pushes water up through black collectors on the roof and the sun warms it. That simplicity is why these systems often run for many years, but the parts that do wear out (valves, sensors, clamps and the collectors themselves) are easier and cheaper to fix early.
You do not need to climb on the roof. From the ground and at the pool equipment you can watch for:
Keep the filter clean and the pump running its normal schedule during the day. A dirty filter cuts flow to the roof and makes the whole system look weaker than it is.
Please do not walk on the collectors or the roof to inspect them. Polymer panels can crack under foot, and roof work is the part best left to a crew that does it every day.
Yes, in a few ways. Strong year round sun and heat age the collectors and rubber parts faster than in milder climates, so a yearly look is worth it even when everything seems fine. After any tropical storm or hurricane, have the array checked before you run it hard again. Hard freezes are rare in most of Central Florida, but a system that does not drain properly can be damaged when one comes, so freeze protection and the vacuum relief valve are part of every visit.
If your pool heater was installed by a company that is no longer in business, it can still be serviced. AllSolar works on solar pool heaters from every brand and installer. Learn more on our solar pool heater repair page.
Many quality polymer collectors last well over a decade in Florida, and some much longer. The actual life depends on the panel, the installation and how the system has been maintained. Cracked or brittle panels can usually be replaced individually instead of replacing the whole array.
Most systems drain themselves through the vacuum relief valve when the pump turns off. That only works if the valve and plumbing slope are working, which is one reason they are checked every year.
The most common causes are a controller or sensor problem, a diverter valve that is not turning, low flow from a dirty filter or weak pump, and leaks or blockages in the collectors. See our repair page for what each one looks like.
Yes. We service solar pool heaters of every brand, including systems whose original installer has closed.
Tell us what you are seeing and we will help you figure out whether it needs a visit.
Contact AllSolarA free Solar Home account keeps your panels, inverter, batteries, pool heater or water heater on record: models, serial numbers, photographs of the labels, warranties, utility and interconnection documents, and every AllSolar service visit attached to your property.
Free to read first, no account needed: the Solar Home guides explain how to identify your equipment, what your production figures mean and what the common warnings are telling you.