common causes, explained below, plus the checks that are safe to do yourself.
Enphase DC Resistance Low, Power Off: What It Means and What to Do
Each IQ microinverter measures the resistance between its panel wiring and ground.
What it means
Each IQ microinverter measures the resistance between its panel wiring and ground. If the reading drops too low, that microinverter stops producing and reports this event. It can come from a temporary cause such as moisture, but the event stays on until someone clears it.
Code: DC Resistance Low, Power Off (solid red LED on the microinverter)
Common causes
- Water or moisture in panel connectors or wiring
- Defective insulation on a module or its leads
- Damaged or pinched DC cables
- A faulty connector or microinverter
Safe checks you can do
- Look in the app for which microinverter has the event and whether it follows wet weather
- Check for roof leaks or obvious storm damage from the ground
- Do not disconnect any DC or AC connectors, which Enphase warns must never be done under load
- When to call a technician
Call a licensed solar technician. An installer needs a gateway connection to clear the event and must find the cause first, or it will come back. Call 866-412-4218 or book online.
Installer out of business?
You can still get this fixed. Enphase backs its own equipment warranty, separate from the company that installed it, and a licensed Florida contractor can diagnose the fault and file the claim. Check whether your installer is still in business.
Source
Explained in our own words from Enphase documentation. AllSolar Energy is not affiliated with Enphase. Never open an inverter or touch roof wiring yourself.
Questions
What does Enphase DC Resistance Low, Power Off (solid red LED on the microinverter) mean?
Each IQ microinverter measures the resistance between its panel wiring and ground. If the reading drops too low, that microinverter stops producing and reports this event. It can come from a temporary cause such as moisture, but the event stays on until someone clears it.
Can I fix it myself?
Look in the app for which microinverter has the event and whether it follows wet weather Check for roof leaks or obvious storm damage from the ground Do not disconnect any DC or AC connectors, which Enphase warns must never be done under load Do not open the inverter or touch DC wiring.
My installer closed. Who fixes a Enphase DC Resistance Low, Power Off (solid red LED on the microinverter)?
Any licensed Florida solar or electrical contractor. Enphase equipment warranties usually survive the installer, and the contractor can file the claim.